Processing colour C-41 films at home

Processing black & white film at home is easy. You just need a changing bag to load the film into a tank in darkness, and the rest can be done in the bathroom with the light turned on. The chemicals for black & white are normally used at 20°C but can be used at room temperature if you compensate for the time. You could even pop the chemicals in the microwave for a few seconds.

Many amateur darkroom enthusiasts (until recently, me included) are wary about developing colour film with the C-41 process, on the assumption that it is difficult, confusing, expensive, or all three.

It is true that colour process has to be more accurately temperature-controlled, and that the development should be done at 38°C. Immediately, this conjures up images of having to buy an expensive electronic water bath, such as the Jobo CPE-2. These machines do help, and they do cost hundreds of pounds. However, they’re not necessary. The development usually takes only 3-4 minutes and the later stages do not have to be quite so accurately controlled. This means it’s possible to use a plain warm water bath.

It’s not too expensive or confusing, either. There are beginner’s kits such as the Rollei Digibase C-41 LT20 which include all of the chemicals you need, with instructions. I paid £25 for a kit that can do about 20 films. There are bigger kits which are better value too, and it’s possible to restock on the individual chemicals in future. I’m no expert on the C-41 process, so you should probably read up on C-41 chemistry yourself.

I bought a wallpaper pasting trough for £2 and made a cardboard lid with holes for my bottles and tank to stand in the water. I filled the trough with water at 50°C and stood the bottles and tank in the water to reach the right temperature. The temperature of the water bath fell rapidly at first, and then slowed down. After about 5 minutes the water bath was at about 40°C so I waited until the temperature fell to 38°C, checked the temperature of the developer as well as the water bath, and set the development process going. The thermometer still read 38°C after the development was up.

By the end of the entire process of developing, stopping, bleaching, fixing and stabilising, the temperature of the water bath had fallen to 35°C, but this is still within tolerances.

My message to photographers who are wary of processing colour film at home: don’t be. You have to be careful, but you don’t need any special equipment other than what you’ve already got for your black & white work.

Have fun!

One Comment

  1. […] my own colour film for the first time. It came out pretty well for a first attempt. I wrote about processing colour film at home on my blog, but for now you can enjoy the best of the […]

Leave a Reply